If you’ve owned a swimming pool for some time now, you must be well aware of how a regular pool pump can turn your great swimming day into an unpleasant one. With extra noise, high electricity bills, and maintenance, a pool can quickly become an unwanted feature of the house. This is why it’s essential to get an inverter pool pump installation in your home immediately.
The new inverter pool pumps have set a new standard in the market due to their high energy-saving potentials. You can buy the great Aquagem’s inverter pool pump through aquagem.com. Getting a professional to do this job would be an intelligent decision. But if you already know a little bit about the process, it’ll be easy to know what’s to come.
1. Select a Pool Pump
This step holds great value as your new pump’s size and layout should be similar to that of your previous one. Aquagem’s official website has several options you can select from. All of them are energy-efficient equipped with InverSilence technology. This helps in reducing carbon footprint excellently. Another great feature is they have a touch-screen that lets you operate with a simple touch.
2. Shut off The Power Supply
It’s essential to keep in mind to turn off the power supply before replacing your swimming pool pump. Never leave it on as it would compromise your own safety. While you’re at it, make sure to shut your inlet and outlet valves of the pipe.
3. Open the Pressure Valve
Another safety measure to perform is to relieve the system of internal pressure. Generally, in a pool pump, the pressure valve is located near the pressure gauge. You’re required to open that particular valve and minimize the pressure build-up in the system.
4. Remove or Unplug the Wires and Pump
After shutting off the power supply and getting rid of the pressure from the system, it’s time to remove all electrical components. This step is quite hazardous and should be restricted solely to the electrician.
First, the wires need to be unplugged from the terminals of the pump. Then the pump itself needs to be isolated from the system. For this step, you are to remove the casing of the pump before disconnecting it. Next, either cut off the pipes or unlink them from the pressure and suction sides. Finally, clean the case of the filter so that it’s free of debris or grease before attaching the new pump.
5. Secure the New Pump in Place
When installing the new pump, you’ll have to fix the suction side first. Once that is done, move on to properly aligning the pipes. Also, if needed, make changes to their size and orientation. Next, fit the pump unions in place and slide the pipes into fittings. It’s crucial to leave some space between the pump union and the fitting.
6. Final Adjustments
When done performing all the above steps correctly, it is time to reconnect the wirings. Ensure that each wire is attached to its dedicated terminal to prevent hazards. Wait a couple of hours before activating the pump. When ready, turn on the valves you were told to shut before and restore the power supply.
That’s it! Your new inverter pool pump installation will be a success if you follow the steps carefully.
